Facemask Transfer Instructions

Iron on Transfers for Face Masks

You can use a standard household iron or a commercial heat press to apply our face mask transfers.  If you get stuck, please reach out to us - we're more than happy to help!

Step 1

Once your order arrives, remove the transfers.  Be sure to check the envelope fully as some transfers can sometimes get stuck.

Step 2

Transfers are often sent on the same sheet, you can use standard scissors to cut the transfers into individual items.

Step 3

Place the letters down on your garment (which should be on a hard flat surface ie. table) in the order you require.

All transfers are mirrored so place them down so they look correctly when viewing the garment.

Step 4

Place a piece of white clean paper over the transfers ensuring that your transfers do not move whilst ironing.

Step 5

Do not Use Steam

All materials are different, and therefore we advise to set your iron at a low temperature first - then follow the rest of the instructions. If the transfers have not fully attached, increase the temperature slightly and repeat until the transfers have stuck correctly - do not exceed the cotton 1 pre-set.

If the plastic carrier is melting your temperature is far too high - please turn down your iron.

Press the iron firmly onto the transfers ensuring you do not move the iron.

Do this for between 15-30 seconds.

Step 6

Remove the paper, and leave to cool for 5-10 seconds.

Slowly peel back the plastic leaving the transfers in place.  If the transfers begin to peel then re-iron for longer and use more pressure.

Step 7

This step is optional.  If your transfers look a little bumpy, then take the piece of white paper, cover the transfers again, and iron normally using a good firm pressure.